Precast Roofing System

Toor Concrete follows the following specifications for the manufacturing of precast & prestressed products. 

  1. ACI 318:83ASTM A615=2002
  2. ASTM A416=8A421

Precast Concrete Paving Blocks

Precast concrete paving blocks (pavers) are manufactured in various sizes and shapes accordance with the British Standard Specifications BS: 6717: Part 1: 1993 average compressive crushing strength 7200 psi, in various shapes, sizes and thickness (50mm, 60mm and 80mm)

According to the above mentioned specifications and stringent control over the material procurement and manufacturing processes, pavers of Toor Concrete Pavers & Tiles have achieved impressive laboratory test results from the University of Engineering and Technology Lahore and Govt. College of  Technology Sahiwal. These test reports have shown that our pavers are undoubtedly of the best quality and are strong enough to achieve compressive strength of    10, 000 psi which is much more than actually required by the technical specifications (7, 000 psi).

Edge Restraints (Kerbstones).

Edge restraints (kerbstones) are required on the edges of concrete segmental pavement to prevent the pavers / asphalt paving from rotating under load. For pavement subject to vehicular traffic the edge restraint must have sufficient stability to withstand occasional vehicle impact. It is recommended that the base be extended to the rear face of the edge restraint.Kerbstones are manufactured in accordance with British Standard Specification 7263, Part 1 of 1994/EN 1341 of 2000 in all required sizes.

Edge Restraints (Kerbstones).

Edge restraints (kerbstones) are required on the edges of concrete segmental pavement to prevent the pavers / asphalt paving from rotating under load. For pavement subject to vehicular traffic the edge restraint must have sufficient stability to withstand occasional vehicle impact. It is recommended that the base be extended to the rear face of the edge restraint.Kerbstones are manufactured in accordance with British Standard Specification 7263, Part 1 of 1994/EN 1341 of 2000 in all required sizes.

Load bearing concrete masonry units (Hollow Blocks, Solid blocks).

Load bearing hollow blocks are manufactured in accordance with ASTM C90-93 in all required sizes.

R.C.C Sewerage Pipes.

Our R.C.C Sewerage pipes are manufactured in accordance with American Society for Testing Materials (ASTM) C-76, British Standard (BS 5911) and other national standards.

Irrigation Nakkas

Toor Concrete Enterprises is manufacturing RCC Panel and Pipe Nakkas manufactured by i/c Lids are strictly in accordance with requirements, specifications, structural designs, and drawings for steel reinforcement and cement concrete approved and obtained from the Directorate of Punjab Water Management Program, Lahore.

We warrant that the products manufactured and supplied by us are in accordance with specifications, drawings, design & requirements of ACI and Punjab Water Management Program Department.